Configuring Device Addresses

You can use the Management tab to configure IPv4 and loopback addresses on the device.

To configure IPv4 and loopback addresses:

  1. In the J-Web user interface, select Configure>System Properties>Management Access.
  2. Click Edit. The Edit Management Access dialog box appears.
  3. Select the Management tab.
  4. If you want to enable a loopback address for the device, enter an address and corresponding subnet mask in the Loopback address section.
  5. If you want to enable an IPv4 address for the device, select IPv4 address and enter a corresponding management port, subnet mask, and default gateway.
  6. Click OK to save the configuration or Cancel to clear it.
Copyright© 2011 Juniper Networks, Inc. All rights reserved.