Chassis Cluster Quick Setup Configuration Page Options
To configure Chassis Cluster Quick Setup:
- In the J-Web interface, select Configure>Chassis Cluster>Setup. The chassis cluster quick setup configuration page is displayed.
- Enter the required configuration values for this page as shown in Table 103.
- Click one:
- Enable—Enables the cluster
mode of the node.
- Enable and Reboot—Reboots the system after setting the identifiers.
- Enable and No Reboot—Sets the identifiers without rebooting the node.
- Disable—Disables the cluster
mode on the node.
- Disable and Reboot—Disables cluster mode and reboots the node.
- Disable and No Reboot—Disables cluster mode without rebooting the node.
- Reset—Resets your entries to the original value.
- Enable—Enables the cluster
mode of the node.
Table 103: Chassis Cluster Quick Setup Configuration Page
| Field | Function | Action |
|---|---|---|
Cluster ID | Specifies the number by which a cluster is identified. | Enter a number from 0 through 15. |
| Node | ||
Node ID | Specifies the number by which a node is identified. | Enter a number from 0 through 1. |
Node Management IP Address (fxp0.0) | Specifies the Management IP address of that Node. | Enter a valid IP address for the management interface. |
| Control Link | ||
Fpc | Specifies the Fpc control link. | Select the fpc number listed in the drop-down. |
Port | Specifies the port to configured for the control link | Enter a number from 0 through 2. |