[Prev][Next][Report an Error]

Configuring Static Routes in J-Web

You can use the J-Web interface to configure static routes.

To configure static routes:

  1. Select Configure>Routing > Static Routing. The Static Routing page displays details of the configured routes.
  2. Click one:

Table 135: Static Routing Configuration Summary

Field

Function

Your Action

Default Route  

Default Route

Specifies the default gateway for the switch.

To specify an IPv4 address:

  1. Select IPv4.
  2. Type an IP address—for example, 10.10.10.10.
  3. Enter the subnet mask or address prefix. For example, 24 bits represents 255.255.255.0.

To specify an IPv6 address:

  1. Select IPv6.
  2. Type an IP address—for example, 2001:ab8:85a3::8a2e:370:7334.
  3. Enter the subnet mask or address prefix.
Static Routes  

Nexthop

Specifies the next-hop address or addresses to be used when routing traffic to the static route.

To add an address:

  1. Click Add.
  2. In the IP address dialog, enter the IP address.

    Note: If a route has multiple next-hop addresses, traffic is routed across each address in round-robin fashion.

  3. Click OK.

To delete a next hop address, select it from the list and click Delete.


[Prev][Next][Report an Error]