Configuring Destination NAT—Quick Configuration

Table 175: Destination NAT Configuration Options

Field	Function	Action
Destination NAT
Destination Address Pool	Defines one or more destination NAT pools.	Click Add.
Destination Rule Sets	Defines one or more rule sets.	Click Add.
Destination NAT Pool
Name	Descriptive name for the pool.	Type a name for the pool.
Routing Instance	Specifies the routing instance in which to perform route lookup for the address in the pool. By default, the routing instance is inet.0.	Enter the routing instance name.
IP Address Range	Specifies an address range.	Enter the IP addresses.
IP Address	Specifies a single IP address.	Enter an IP address.
Port	Specifies the optional port number.	Enter a port number.
Destination NAT Rule Set
Name	Name of the rule set.	Type a name for the rule set.
From	Specifies where the packet is coming from. If a packet matches more than one rule set, the rule set with the more specific match is used. An interface match is considered more specific than a zone match, which is more specific than a routing instance match.	Routing Instance—Specify the source routing instance. Interface—Specify the source interface. Zone—Specify the source zone.
Rules	Set of conditions that are evaluated, in order, for a match to perform the specified destination NAT action.
Rule name	Name of the destination NAT rule.	Type a name for the rule.
Source address	Specifies the source address to match. You can configure multiple addresses or subnets.	Enter one or more addresses or subnets.
Destination address	Specifies the destination address to match. You can configure multiple addresses or subnets.	Enter one or more addresses or subnets.
Destination port	Specifies the destination port to match.	Enter a single port number.
Then	Specifies the action of the destination NAT rule.	Destination nat off—No destination NAT is performed. Destination NAT pool—Use the specified pool to perform destination NAT.