[Prev][Next][Report an Error]

Configuring the SCCP ALG—Quick Configuration

You can use J-Web Quick Configuration to quickly configure SCCP ALG Parameters

Figure 60 shows the SCCP ALG configuration page.

Figure 60: SCCP ALG Configuration

SCCP ALG Configuration

To configure the SCCP ALG with Quick Configuration:

  1. In the J-Web user interface, select Configure>Security>ALGs>VoIP.
  2. Select the SCCP tab if it is not selected.
  3. Enter your parameter settings as described in Table 171 and click one of the following buttons:

Table 171: SCCP ALG Configuration Options

Enable SCCP ALG

Enables or disables the SCCP ALG.

Click the check box.

Inactive Media Timeout

Indicates the maximum length of time (in seconds) a call can remain active without any media (RTP or RTCP) traffic within a group. Each time an RTP or RTCP packet occurs within a call, this timeout resets. When the period of inactivity exceeds this setting, the Skinny Client Control Protocol (SCCP) ALG the gates opened for media are closed.

Select a value from 10 to 600 seconds.

Call Flood Threshold

Protect Skinny Client Control Protocol (SCCP) ALG clients from flood attacks by limiting the number of calls they attempt to process

Select a value from 2 to 1,000.

Permit NAT Applied Unknown Message

Specifies how unidentified SCCP messages are handled by the device. The default is to drop unknown (unsupported) messages. Permitting unknown messages can compromise security and is not recommended. However, in a secure test or production environment, this statement can be useful for resolving interoperability issues with disparate vendor equipment. By permitting unknown SCCP (unsupported) messages, you can get your network operational and later analyze your VoIP traffic to determine why some messages were being dropped.

This statement applies only to received packets identified as supported VoIP packets. If a packet cannot be identified, it is always dropped. If a packet is identified as a supported protocol, the message is forwarded without processing.

Click the check box.

 

Permit Routed Unknown Message

Specifies that unknown messages be allowed to pass if the session is in Route mode. (Sessions in Transparent mode are treated as Route mode.)

Click the check box.


[Prev][Next][Report an Error]