Configuring Proxy ARP (CLI Procedure)

You use NAT proxy ARP functionality to configure proxy ARP entries for IP addresses that require either source or destination NAT and that are in the same subnet as the ingress interface.

Note: On SRX Series devices, you must explicitly configure NAT proxy ARP.

When configuring NAT proxy ARP, you must specify the logical interface on which to configure proxy ARP. Then you enter an address or address range.

The device performs proxy ARP for the following conditions:

• When addresses defined in the static NAT and source NAT pool are in the same subnet as that of the ingress interface
• When addresses in the original destination address entry in the destination NAT rules are in the same subnet as that of the ingress interface

Related Topics

• Junos OS Feature Support Reference for SRX Series and J Series Devices
• Static NAT Configuration Overview
• Destination NAT Configuration Overview
• Source NAT Configuration Overview