 |
Note: To clear the statistics for the individual switch ports using the clear interfaces statistics ge-pim/0/0 switch-port port-number command. |
The operational mode command for checking the status and statistics for multiport uPIMs switching mode is different from that of routing mode. For uPIMs in routing mode, the operational commands are the same as for other Gigabit Ethernet interfaces, such as the 1-port Gigabit Ethernet ePIM and built-in Gigabit Ethernet ports.
Not all operational mode commands are supported for ports of a uPIM in switching mode. For example, the operational mode command for monitoring port statistics is not supported.
|
Note: To clear the statistics for the individual switch ports using the clear interfaces statistics ge-pim/0/0 switch-port port-number command. |
To verify the status and view statistics for a port on a uPIM in switching mode.
From the CLI, enter the show interfaces ge-pim/0/0 switch-port port-number command.
user@host show interfaces ge-pim/0/0 switch-port port-number
Port 0, Physical link is Up
Speed: 100mbps, Auto-negotiation: Enabled
Statistics: Receive Transmit
Total bytes 28437086 21792250
Total packets 409145 88008
Unicast packets 9987 83817
Multicast packets 145002 0
Broadcast packets 254156 4191
Multiple collisions 23 10
FIFO/CRC/Align errors 0 0
MAC pause frames 0 0
Oversized frames 0
Runt frames 0
Jabber frames 0
Fragment frames 0
Discarded frames 0
Autonegotiation information:
Negotiation status: Complete
Link partner:
Link mode: Full-duplex, Flow control: None, Remote fault: OK, Link partner Speed: 100 Mbps
Local resolution:
Flow control: None, Remote fault: Link OK