Verifying RSVP Sessions

Purpose

Verify that an RSVP session has been established between all RSVP neighbors. Also, verify that the bandwidth reservation value is active.

Action

From the CLI, enter the show rsvp session detail command.

Ingress RSVP: 1 sessions

10.0.9.7
  From: 10.0.6.1, LSPstate: Up, ActiveRoute: 0
  LSPname: r1–r7, LSPpath: Primary
  Bidirectional, Upstream label in: –, Upstream label out: -
  Suggested label received: -, Suggested label sent: –
  Recovery label received: -, Recovery label sent: 100000
  Resv style: 1 FF, Label in: -, Label out: 100000
  Time left:    -,  Since: Thu Jan 26 17:57:45 2002
  Tspec: rate 10Mbps size 10Mbps peak Infbps m 20 M 1500
  Port number: sender 3 receiver 17 protocol 0
  PATH rcvfrom: localclient
  PATH sentto: 10.0.4.13 (ge-0/0/1.0) 1467 pkts
  RESV rcvfrom: 10.0.4.13  (ge-0/0/1.0) 1467 pkts
  Record route: <self> 10.0.4.13  10.0.2.1  10.0.8.10  
 

Meaning

The output shows the detailed information, including session IDs, bandwidth reservation, and next-hop addresses, for each established RSVP session. Verify the following information:

• Each RSVP neighbor address has an entry for each neighbor, listed by loopback address.
• The state for each LSP session is Up.
• Under Tspec, the appropriate bandwidth value, 10Mbps, appears.

Related Topics

For a complete description of show rsvp session detail output, see the JUNOS Routing Protocols and Policies Command Reference.