Displaying Installed Licenses

Purpose

Verify that the expected licenses are installed and active on the Services Router.

Action

From the CLI, enter the show system license command.

License usage: 
                   Licenses     Licenses    Licenses 
  Feature name         used    installed      needed 
  j-flow                  0            1           0
  bgp-reflection          0            1           0
  dlsw                    0            1           0

Licenses installed: 
  License identifier: G03000002223
  State: valid
  License version: 2
  Valid for device: JN001875AB
  Features:
    bgp-reflection   - Border Gateway Protocol route reflection

  License identifier: G03000002224
  State: valid
  License version: 2
  Valid for device: JN001875AB
  Features:
    dlsw             - Data-Link Switching (DLSw) protocol

  License identifier: G03000002225
  State: valid
  License version: 2
  Valid for device: JN001875AB
  Features:
    j-flow           - J-FLOW traffic analysis (CFLOW reporting)

What it Means

The output shows a list of the license usage and a list of the licenses installed on the Services Router. Verify the following information:

• Each license is present. Licenses are listed in ascending alphanumeric order by license ID.
• The state of each license is valid.

  A state of invalid indicates that the license key is not a valid license key. Either it was entered incorrectly or it is not valid for the specific device.

• The feature for each license is the expected feature. The features enabled are listed by license. An all-inclusive license has All features listed.
• All configured features have the required licenses installed. The Licenses needed column must show that no licenses are required.