[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

TIM508 Analog Telephony Interface Module

The TIM508 Analog Telephony Interface Module (Figure 42), also known as the TIM508 analog media module, has eight analog telephone lines that can be used as trunk ports.

Figure 42: TIM508 Analog Telephony Interface Module

Image g003865.gif

Note: All eight analog lines can be configured as analog direct inward (DID) trunks.

You can configure TIM508 ports as described in Table 38.

Table 38: TIM508 Possible Port Configurations

Possible Analog Telephone Line Configurations
Wink-start or immed-start DID trunk
Analog tip/ring devices such as single-line telephones with or without LED message-waiting indication

The TIM508 also provides the following features:

Three ringer loads, the ringer equivalency number for up to 2,000 ft (610 m), for all eight lines
Up to eight simultaneously ringing lines
Type 1 caller ID and Type 2 caller ID for lines
Ring voltage generation for a variety of international frequencies and cadences

For pinouts of cable connectors for the TIM508, see TIM508 Connector Pinout.

To install or remove an Avaya VoIP module, see Replacing a PIM.

TIM508 LEDs indicate link status and activity. Table 39 describes the meaning of the LEDs.

Table 39: LEDs for TIM508

Label	Color	State	Description
ALM	Red	On steadily	Alarm. A TIM508 failure requires monitoring or maintenance.
ACT	Yellow	Blinking	Active. A device connected to the TIM508 is in use. This situation can include a telephone that is off the hook.

For more information about the TIM508, see the Avaya manual Hardware Description and Reference for Avaya Communication Manager.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]