Removing and Replacing the Chassis Cover on J2320 and J2350 Routers

On J2320 and J2350 routers, the chassis cover fits tightly on the chassis. To remove the cover from the chassis:

1. Press and release the power button to power off the router. Wait for the POWER LED to turn off.
2. Remove the power cable from the power source receptacle.
3. With a Phillips screwdriver remove the grounding screw.
4. Remove the router from the rack.
5. With a Phillips screwdriver remove the flat head screws from the rear and sides of the chassis.
6. Position the router so that you face the front panel.
7. Place your hands on the cover and press down while pushing the cover back until the two front tabs disengage from the chassis base (see Figure 75).

   Figure 75: Sliding the Chassis Cover

   

8. Lift the cover upward and pull it away from the tabs on the rear of the chassis (see Figure 76).

   Figure 76: Removing and Replacing the Chassis Cover

   

To replace the cover on the J2320 and J2350 chassis:

1. Lower the cover onto the chassis so that the front edge of the cover is a few inches away from the front edge of the chassis base (see Figure 76).
2. Tilt the cover and align the rear tabs with the slots at the bottom of the chassis (see Figure 77).

   Figure 77: Matching the Chassis Slots and Tabs

   

3. Lower the cover fully onto the base, and slide it so that the front tabs match the front slots and the chassis cover and base edges align completely.
4. Insert and tighten the flat head screws with a Phillips screwdriver.
5. Return the router to its installation site, and attach the grounding cable and the power cables. (See Connecting Power.)
6. Press and release the power button to power on the router. Verify that the POWER LED lights steadily.