The power button is located on the left side of the front panel (see Figure 19). You can use the power button to power the Services Router on and off. When you power on the router, the Routing Engine boots as the power supply completes its startup sequence.
The POWER LED is located to the upper left of the LED dashboard. Table 12 describes the POWER LED.
Table 12: POWER LED
After the router is powered on, status indicators—such as LEDs on the front panel and show chassis command output—can take up to 60 seconds to indicate that the power supply is functioning normally. Ignore error indicators that appear during the first 60 seconds.
If you need to power off the router after the Routing Engine finishes booting, use the J-Web interface or the CLI to halt the Services Router first. For instructions, see the J-series Services Router Administration Guide. Alternatively, you can press and release the power button to gracefully shut down the router. For more information, see Powering a Services Router On and Off.