[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Configuring VoIP Interfaces with Quick Configuration

You can use the VoIP Interfaces Quick Configuration pages to configure the VoIP interface on a router.

To configure a VoIP interface with Quick Configuration:

From the Quick Configuration page, as shown in Figure 22, select the VoIP interface—for example, vp-5/0/0—you want to configure.
For information about interface names, see Network Interface Naming.
Enter information into the Quick Configuration page, as described in Table 106.
Click one of the following buttons:
- To apply the configuration and stay on the Quick Configuration page, click Apply.
- To apply the configuration and return to the main configuration page, click OK.
- To cancel your entries and return to the main page, click Cancel.
To verify that the VoIP interface is configured correctly, see Verifying the VoIP Configuration.

Table 106: VoIP Interface Quick Configuration Page Summary

Field	Function	Your Action
VoIP Logical Interfaces
Add logical interfaces	Defines logical unit 0 that you connect to the physical VoIP interface. You must define one logical unit for the VoIP interface. Note: You cannot define more than one logical unit for the VoIP interface. The logical unit number must be 0.	Click Add.
Logical Interface Description	(Optional) Describes the logical interface.	Type a text description of the logical interface to more clearly identify it in monitoring displays.
IPv4 Address and Prefix	Specifies the IPv4 address for the interface. The following rules apply: You cannot specify more than one IPv4 address. Do not assign the following IPv4 addresses: A broadcast address (`255.255.255.255`) A class E address (`240.0.0.0` to `255.255.255.254`) A loopback address (`127.0.0.0` to `127.255.255.255`) A multicast address (`224.0.0.0` to `239.255.255.255`) An address with 0 as the first byte or an address with 0 or 255 as the last byte The VoIP interface needs a point-to-point connection to the TGM550. To configure the point-to-point connection, specify /32 as the subnet mask in the IPv4 address.	Type the IPv4 address with /32 as the subnet mask. For example: 10.10.10.1/32
Destination Address	Specifies the IP address of the TGM550. Caution: Applying a new or modified IP address resets the TGM550. For existing configurations, ensure that the TGM550 configuration is saved (see Saving the TGM550 Configuration) and that the TGM550 module is carrying no voice traffic. You cannot specify more than one IP address. For more information, see TGM550 IP Addressing Guidelines.	Type the IP address of the TGM550—for example, 10.10.10.2.
Physical Interface Description	(Optional) Adds supplemental information about the VoIP physical interface on the router.	Type a text description of the physical VoIP interface in the box to clearly identify it in monitoring displays.
TGM Configuration
MGC List	Specifies the IP address of at least one and up to four Media Gateway Controllers (MGCs) with which the TGM550 must be registered. The first MGC in the list is the primary MGC. The TGM550 searches for the primary MGC first. If it cannot connect to the primary MGC, the TGM550 searches for the next MGC on the list, and so on.	Type the IP address of the MGC. Click Add. To delete an IP address, select it in the MGC List box, then click Delete.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]