[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Configuring LLC Type 2 Properties on an Ethernet Interface

Before configuring DLSw on the Services Router, you must configure the LLC type 2 properties on the Ethernet interfaces of the router. The Logical Link Control (LLC) layer is one of two sublayers into which the OSI data link layer is subdivided for data link protocols used on the LAN. LLC type 2 is implemented anytime SNA is running on a LAN or virtual LAN.

Note: LLC type 2 properties must be configured on the local Services Router and the remote Services Router.

To configure LLC type 2 properties:

  1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
  2. Perform the configuration tasks described in Table 59.
  3. Go on to one of the following required configurations:
  4. To verify the basic DLSw properties, see Verifying DLSw Configuration.

Table 59: Configuring LLC Type 2 Properties on a Fast Ethernet Interface

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Interfaces level in the configuration hierarchy and select a Fast Ethernet interface—for example, fe-3/0/1.
  1. In the J-Web interface, select Configuration>View and Edit>Edit Configuration.
  2. Next to Interfaces, click Configure or Edit.
  3. Click fe-3/0/1.

From the [edit] hierarchy level, enter

edit interfaces fe-3/0/1

Configure LLC type 2 properties on the fe-3/0/1 interface.
  1. Under Unit and Interface unit number, click 0.
  2. Under Family, select Llc2.
  3. Click OK until you return to the main Configuration page.
  1. Enter

    edit unit 0

  2. Enter

    set family llc2

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

[an error occurred while processing this directive]