[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Configuring a Policy Term (Required)

Each routing policy term is identified by a term name. The name can contain letters, numbers, and hyphens (-) and can be up to 255 characters long. To include spaces in the name, enclose the entire name in double quotation marks.

To configure a policy term:

Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
Perform the configuration tasks described in Table 77.
If you are finished configuring the router, commit the configuration.
To configure additional routing policy features, go on to one of the following procedures:
- To remove useless routes, see Rejecting Known Invalid Routes (Optional).
- To advertise additional routes, see Injecting OSPF Routes into the BGP Routing Table (Optional).
- To create a forwarding class, see Grouping Source and Destination Prefixes in a Forwarding Class (Optional).
- To make a route less preferable to BGP, see Configuring a Policy to Prepend the AS Path (Optional).
- To suppress route information, see Configuring Damping Parameters (Optional).

Table 77: Configuring a Policy Term

Task	J-Web Configuration Editor	CLI Configuration Editor
Navigate to the Policy statement level in the configuration hierarchy.	In the J-Web interface, select Configuration>View and Edit>Edit Configuration. Next to Policy options, click Configure or Edit. Under Policy name, click policy1.	From the [edit] hierarchy level, enter edit policy-options policy-statement policy1
Create and name a policy term—for example, term1.	In the Term box, click Add new entry. In the Term name box, type term1. Click OK.	Create and name a policy term: set term term1

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Policy statement level in the configuration hierarchy.

In the J-Web interface, select Configuration>View and Edit>Edit Configuration.
Next to Policy options, click Configure or Edit.
Under Policy name, click policy1.

From the [edit] hierarchy level, enter

edit policy-options policy-statement policy1

Create and name a policy term—for example, term1.

In the Term box, click Add new entry.
In the Term name box, type term1.
Click OK.

Create and name a policy term:

set term term1

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]