Verify that the RPM configuration is within the expected values.
From configuration mode in the CLI, enter the show services rpm command.
user@host# show services rpm
probe test {
test customerA {
probe-type icmp-ping;
target address 192.178.16.5;
probe-count 15;
probe-interval 1;
hardware-timestamp;
}
test customerB {
probe-type icmp-ping-timestamp;
target address 192.178.16.5;
probe-count 15;
probe-interval 1;
hardware-timestamp;
}
test customerC {
probe-type udp-ping;
target address 192.178.16.5;
probe-count 15;
probe-interval 1;
destination-port 50000;
hardware-timestamp;
}
}
The output shows the values that are configured for RPM on the Services Router.