Changes in Default Behavior and Syntax

• SFP information included in operational command output (J-series Services Routers)—For 6-port Gigabit Ethernet uPIMs with small form-factor pluggable transceivers (SFPs) on J-series Services Routers, the show chassis hardware command output now displays information about the SFPs.
• Behavior change for PAP (J-series Services Routers)—If you configure passive mode for Password Authentication Protocol (PAP) on an ATM interface configured for Point-to-Point Protocol over Ethernet (PPPoE) over ATM, the router no longer indicates that it can be the Link Control Protocol (LCP) authenticator during LCP negotiations. Previously, the router did indicate it could be the LCP authenticator, even in passive mode.
• Operational mode output change (J2320, J2350, J4350, and J6350 Services Routers)—Previously, the show chassis fpc command output for selected J-series Services Routers showed just the slot into which a 2-slot-high PIM was physically inserted. Now the output of the show chassis fpc, show chassis fpc slot, and show chassis fpc slot detail commands also indicate the slot that is unusable.