 |
Do not leave a power supply slot empty for more than a short time while the Services Router is operational. The power supply or a blank power supply panel must remain in the chassis for proper airflow. |
The power cords on all Services Routers are replaceable.
You can add a second power supply to the J6300 Services Router that is of the same type as the first (either AC or DC).
The power supplies are located at the right rear of the chassis (see Figure 10 or Figure 11). Each J6300 power supply provides power to all components in the router. The J6300 power supplies are fully redundant. If one power supply fails or is removed, the remaining power supply instantly assumes the entire electrical load. One power supply can provide full power for as long as the router is operational.
Each J6300 power supply is hot-insertable and hot-removable.
|
Do not leave a power supply slot empty for more than a short time while the Services Router is operational. The power supply or a blank power supply panel must remain in the chassis for proper airflow. |
To replace power system components, use the following procedures: