AC Power, Connection, and Power Cord Specifications

The AC power cord for the Services Router is intended for use with the router only and not for any other use.

Detachable AC power cords, each 2.5 m (approximately 8 ft) long, are supplied with the Services Router. The appliance coupler at the female end of the cord inserts into the appliance inlet on the faceplate of the AC power supply. The coupler is type C19 as described by International Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the power cord fits into the power source receptacle that is standard for your geographical location.

In North America, AC power cords must not exceed 4.5 m (approximately 14.75 ft) in. length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3). The cords supplied with the router are in compliance.

Table 40 lists AC power cord specifications provided for each country or region.

Table 40: AC Power Cord Specifications

Figure 32 illustrates the plug on the power cord for each country or region listed in Table 40.

Power cords and cables must not block access to router components or drape where people might trip on them.

For information about the AC power supply, see J4350 Power System or J6350 Power System.

To connect the power cord during initial installation, see Connecting Power.

To replace the AC power cord, see Replacing an AC Power Supply Cord.