[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

TIM514 Analog Telephony Interface Module

The TIM514 Analog Telephony Interface Module (Figure 27), also known as the TIM514 analog media module, has four analog telephone ports and four analog trunk ports.

Figure 27: TIM514 Analog Telephony Interface Module

Image g003857.gif

For analog direct inward dialing (DID) trunks, you must use the four analog telephone (LINE) ports. You cannot use the four analog trunk (TRUNK) ports for analog DID trunks.

You can configure TIM514 ports as described in Table 30.

Table 30: TIM514 Possible Port Configurations

Possible Analog Telephone (LINE) Port Configurations	Possible Analog Trunk (TRUNK) Port Configurations
Wink-start or immediate-start DID trunk	Loop-start or ground-start central office trunk with a loop current of 18 milliamperes (mA) to 120 mA
Analog tip/ring devices such as single-line telephones with or without LED message-waiting indication	Two-wire analog outgoing centralized automatic message accounting (CAMA) emergency E911 trunk, for connectivity to the PSTN Multifrequency (MF) signaling is supported for CAMA ports.

Possible Analog Telephone (LINE) Port Configurations

Possible Analog Trunk (TRUNK) Port Configurations

Wink-start or immediate-start DID trunk

Loop-start or ground-start central office trunk with a loop current of 18 milliamperes (mA) to 120 mA

Analog tip/ring devices such as single-line telephones with or without LED message-waiting indication

Two-wire analog outgoing centralized automatic message accounting (CAMA) emergency E911 trunk, for connectivity to the PSTN

Multifrequency (MF) signaling is supported for CAMA ports.

The TIM514 also provides the following features:

Three ringer loads, the ringer equivalency number for up to 2,000 ft (610 m), for all eight ports
Up to four simultaneously ringing ports
Type 1 caller ID and Type 2 caller ID
Ring voltage generation for a variety of international frequencies and cadences

For pinouts of cable connectors for the TIM514, see TIM514 Connector Pinout.

For information about installing and removing an Avaya VoIP module, see Replacing a PIM.

TIM514 LEDs indicate link status and activity. Table 31 describes the meaning of the LEDs.

Table 31: LEDs for TIM514

Label	Color	State	Description
ALM	Red	On steadily	Alarm. A TIM514 failure requires monitoring or maintenance.
ACT	Yellow	Blinking	Active. A device connected to the TIM514 is in use. This situation can include a telephone that is off the hook.

For more information about the TIM514, see the Avaya manual Hardware Description and Reference for Avaya Communication Manager.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]