Dual-Port Channelized T1 or E1 PIM

The Dual-Port Channelized T1 or E1 PIM (Figure 15) is a multiflex interface card that allows you to configure a single interface as a channelized T1 interface or a channelized E1 interface. The channelized T1 or E1 interface supports up to 24 DS0 channels on a T1 interface and up to 32 DS0 channels on an E1 interface, in addition to supporting the features of regular (unchannelized) T1 and E1 PIMs. Each interface can be configured as a single clear channel, fractionalized, or channelized interface.

You cannot configure a channelized T1 or E1 interface through a J-Web Quick Configuration page.

The Dual-Port Channelized T1 or E1 PIM provides the following key features:

• Onboard network processor
• Two-port channelization
• Interfaces that are software configurable as T1 or E1
• Clear-channel, fractional, and channelized operation
• Lower latency due to the addition of a Freescale processor
• Maximum MTU value of 4500 bytes (for channelized T1 or E1 interface)

  For a clear-channel T1 or E1 interface, the maximum MTU is 9150 bytes.

• 56-Kbps and 64-Kbps modes
• ANSI T1.102, T1.107, and T1.403 standards compliance
• G.703, G.704, and G.706 E1 standards compliance
• Independent internal and external clocking system
• Loopback, bit error rate test (BERT), T1 facilities data link (FDL), and long buildout diagnostics

For pinouts of cable connectors for channelized T1 and E1 PIMs, see E1 and T1 RJ-48 Cable Pinouts.

For alarms, see the configuring and monitoring alarms information in the J-series Services Router Administration Guide.

For installing and removing a PIM, see Replacing a PIM.

Channelized T1 and E1 LEDs indicate PIM and port status. Table 19 describes the meaning of the LED states.

Table 19: LEDs for Channelized T1 and E1 PIMs