[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Configuring PPPoE Encapsulation on an Ethernet Interface

Both the client and the server must be configured to support PPPoE.

To configure PPPoE encapsulation on an Ethernet interface:

Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
Perform the configuration tasks described in Table 48.
If you are finished configuring the router, commit the configuration.
Go on to one of the following procedures:
- To configure the PPPoE interface, see Configuring a PPPoE Interface (Required).
- To enable authentication on the interface, see Configuring CHAP on a PPPoE Interface (Optional).
- To check the configuration, see Verifying a PPPoE Configuration.

Table 48: Configuring PPPoE Encapsulation on an Ethernet Interface

Task	J-Web Configuration Editor	CLI Configuration Editor
Navigate to the Interfaces level in the configuration hierarchy.	In the J-Web interface, select Configuration>Edit Configuration>View and Edit. Next to Interfaces, click Configure or Edit.	From the [edit] hierarchy level, enter edit interfaces
Configure encapsulation on a logical Ethernet interface—for example, ge-0/0/1.0. For information about interface names, see Network Interface Naming.	In the Interface name box, click ge-0/0/1. In the Interface unit number box, click 0. From the Encapsulation list, select ppp-over-ether. Click OK.	Set PPP encapsulation on unit 0 of the Ethernet interface: set ge-0/0/1 unit 0 encapsulation ppp-over-ether

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Interfaces level in the configuration hierarchy.

From the [edit] hierarchy level, enter

edit interfaces

Configure encapsulation on a logical Ethernet interface—for example, ge-0/0/1.0.

For information about interface names, see Network Interface Naming.

Set PPP encapsulation on unit 0 of the Ethernet interface:

set ge-0/0/1 unit 0 encapsulation ppp-over-ether

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]