Configuring ATM-over-ADSL Interfaces

Services Routers with ADSL Annex A or Annex B PIMs can use an Asynchronous Transfer Mode (ATM) interface to send network traffic through a point-to-point connection to a DSL access multiplexer (DSLAM). ADSL is currently not supported on the J2300 Services Router.

You can configure Services Routers with ADSL PIMs for connections through ADSL only, not for direct ATM connections.

To configure Point-to-Point Protocol (PPP), see the JUNOS Network Interfaces Configuration Guide.

You configure the underlying ADSL interface as an ATM interface, with an interface name of at-pim/0/port. (For information about interface names, see Network Interface Naming.) Multiple encapsulation types are supported on both the physical and logical ATM-over-ADSL interface.

This section contains the following topics:

• Configuring an ATM-over-ADSL Interface with Quick Configuration
• Adding an ATM-over-ADSL Network Interface with a Configuration Editor