[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Configuring DLSw on the Remote Services Router

To configure DLSw on the remote Services Router, you do the following:

To configure DLSw on a remote router:

  1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
  2. Perform the configuration tasks described in Table 62.
  3. If you are finished configuring the router, commit the configuration.
  4. To verify the DLSw configuration, see Verifying DLSw Configuration.

Table 62: Configuring DLSw on the Remote Router

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Dlsw level in the configuration hierarchy.
  1. In the J-Web interface, select Configuration>View and Edit>Edit Configuration.
  2. Next to Protocols, click Configure or Edit.
  3. Next to Dlsw, make sure the check box is selected, and click Configure or Edit.

From the [edit] hierarchy level, enter

edit protocols dlsw

Configure the local router properties.

promiscuous—Allows all incoming peer connections.
  1. In the Local peer box, type 217.110.111.134.
  2. Next to Promiscuous, select Yes.
  3. Click OK.
  1. Enter

    set local-peer 217.110.111.134

  2. Enter

    set promiscuous

If the values connection-idle-timeout, dlsw-cos, local-peer, multicast-address, promiscuous, and receive-initial-pacing are modified, any existing DLSw peer connection is torn down. If remote-peer peer-address is added or removed, only that remote peer and its associated circuits are affected.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

[an error occurred while processing this directive]