AC Power, Connection, and Power Cord Specifications

The AC power cord for the Services Router is intended for use with the router only and not for any other use.

Detachable AC power cords, each 2.5 m (approximately 8 ft) long, are supplied with the Services Router. The appliance coupler at the female end of the cord inserts into the appliance inlet on the faceplate of the AC power supply. The coupler is type C19 as described by International Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the power cord fits into the power source receptacle that is standard for your geographical location.

In North America, AC power cords must not exceed 4.5 m (approximately 14.75 ft) in. length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3). The cords supplied with the router are in compliance.

Table 32 lists power cord specifications and Figure 28 illustrates the plug on the AC power cord provided for each country or region.

Table 32: AC Power Cord Specifications

Power cords and cables must not block access to router components or drape where people might trip on them.

For information about the AC power supply, see J4350 Power System or J6350 Power System.

To connect the power cord during initial installation, see Connecting Power.

To replace the AC power cord, see Replacing an AC Power Supply Cord.