TIM514 Analog Telephony Interface Module PIM

The TIM514 Analog Telephony Interface Module PIM (Figure 45) has four analog telephone ports and four analog trunk ports.

The four analog trunk ports cannot be used for analog DID trunks. Instead, the four analog telephone ports must be used.

You can configure any of the four line ports as:

• A wink start or an immediate start DID trunk
• Analog tip/ring devices such as single-line telephones with or without LED message waiting indication

You can configure any of the four trunk ports as:

• A loop start or a ground start central office trunk with a loop current of 18 to 120 mA
• A two-wire analog Outgoing CAMA E911 trunk, for connectivity to the PSTN. MF signaling is supported for CAMA ports.

The TIM514 PIM also provides the following features:

• Three ringer loads, which is the ringer equivalency number for up to 2,000 feet (610 meters) for all eight ports
• Up to four simultaneously-ringing ports
• Type 1 caller ID and Type 2 caller ID
• Ring voltage generation for a variety of international frequencies and cadences

For pinouts of cable connectors for TIM514 PIMs, see TIM514 Connector Pinout.

For information about installing and removing a PIM, see the J4350 and J6350 Services Router Getting Started Guide.

TIMs are not hot-swappable. You must power off the router before the installing or removing the Avaya VoIP modules. Ensure that the Avaya VoIP modules are installed in the router chassis before booting up the system.

TIM514 LEDs indicate link status and activity. Table 102 describes the meaning of the LEDs.

Table 102: LEDs for TIM514 PIM

For more information about the TIM514, see the Hardware Description and Reference for Avaya Communication Manager.