[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

TIM510 DS1 Telephony Interface Module PIM

The TIM510 DS1 Telephony Interface Module PIM (Figure 44) terminates a T1 or E1 trunk. The TIM510 has a built-in Channel Service Unit (CSU) so an external CSU is not necessary. The CSU is only used for the T1 circuit.

Figure 44: TIM510 DS1 Telephony Interface Module PIM

Image g003856.gif

The TIM510 PIM provides the following key features:

ISDN PRI capability (23B + D or 30B + D)
Trunk signaling to support US and International CO or tie trunks
Echo cancellation in either direction—incoming or outgoing

For pinouts of cable connectors for TIM510, see TIM510 RJ-45 Connector Pinout.

For information about installing and removing a PIM, see the J4350 and J6350 Services Router Getting Started Guide.

TIMs are not hot-swappable. You must power off the router before the installing or removing the Avaya VoIP modules. Ensure that the Avaya VoIP modules are installed in the router chassis before booting up the system.

TIM510 LEDs indicate link status and activity. Table 101 describes the meaning of the LEDs.

Table 101: LEDs for TIM510 PIM

Label	Color	State	Description
ALM	Red	On steadily	A failure that requires monitoring or maintenance.
ACT	Green	On steadily	Online with network traffic.
TST	Yellow	On steadily	Either a test is being performed on the TIM510 via the Media Gateway Controller (MGC), or the TIM510 is performing a self-test upon initial insertion.
SIG	Green	On steadily	This LED indicates whether the link to the Central Office (CO) is up (equivalent to the TN464F circuit pack Status 3 GREEN LED). The physical connection is up.

For more information about the TIM510, see the Hardware Description and Reference for Avaya Communication Manager.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]