[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Configuring the Services Router to Reject Incoming ISDN Calls

By default, the Services Router is configured to accept incoming ISDN calls. The incoming calls are accepted if dial-in is configured on the Services Router. You can configure the Services Router to reject all incoming ISDN calls.

To configure the Services Router to reject incoming ISDN calls:

  1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
  2. Perform the configuration tasks described in Table 64Table 80.
  3. If you are finished configuring the router, commit the configuration.
  4. To verify that the network interface is configured correctly, see Verifying the ISDN ConfigurationVerifying the ISDN Configuration.

Table 80: Configuring the Services Router to Reject Incoming ISDN Calls

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Processes level in the configuration hierarchy.

  1. In the J-Web interface, select Configuration>View and Edit>Edit Configuration.
  2. Next to System, click Edit.
  3. Next to Processes, click Configure.
  4. Next to Isdn signaling, click Configure.

From the [edit] hierarchy level, enter

set system processes isdn-signaling reject-incoming

Configure the Services Router to reject incoming calls.
  1. Select the Reject Incoming check box.
  2. Click OK.
 
[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

[an error occurred while processing this directive]