[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Configuring ES-IS

If a Services Router is a PE router within a CLNS island that contains any end systems, you must configure ES-IS on the Services Router.

To configure ES-IS for the Services Router:

  1. Navigate to the top of the configuration hierarchy in either the J-Web or the CLI configuration editor.
  2. Perform the configuration tasks described in Table 23.
  3. If you are finished configuring the router, commit the configuration.
  4. If applicable, go on to one of the following tasks:

Table 23: Configuring ES-IS

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Routing instances level in the configuration hierarchy.
  1. In the J-Web interface, select Configuration>View and Edit>Edit Configuration.
  2. Next to Routing instances, click Configure or Edit.
  3. Under Instance name, click aaaa.

From the [edit] hierarchy level, enter

edit routing-instances aaaa

Enable ES-IS on all interfaces.
  1. Next to Protocols, click Configure.
  2. Next to Esis, click Configure.
  3. Next to Interface, click Add new entry.
  4. In the Interface name box, type all.
  5. Click OK until you return to the Protocols statement page.

Enter

set protocols esis interface all

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

[an error occurred while processing this directive]