Configuring an IPSec Tunnel with Quick Configuration

J-Web Quick Configuration allows you to create IPSec tunnels. Figure 7 shows the Quick Configuration page for IPSec tunnels.

Figure 7: Quick Configuration Page for IPSec Tunnels

Image s020225.gif

To configure an IPSec tunnel with Quick Configuration:

In the J-Web interface, select Configuration>Quick Configuration>IPSec Tunnels.
In the IPSec Tunnels Quick Configuration main page, click Add.
Enter information into the Quick Configuration page for IPSec Tunnels, as described in Table 28.
From the IPSec Tunnels Quick Configuration main page, click one of the following buttons:
- To apply the configuration and stay on the IPSec Tunnels Quick Configuration page, click Apply.
- To apply the configuration and return to the Quick Configuration main page, click OK.
- To cancel your entries and return to the Quick Configuration main page, click Cancel.
To use digital certificates for authentication, see Configuring Digital Certificates for IPSec Tunnels.
To check the configuration, see Verifying the IPSec Tunnel Configuration.

Table 28: IPSec Tunnels Quick Configuration Summary

Field	Function	Your Action
Tunnel Information
Local Tunnel Endpoint (required)	Externally routable IP address that is the local endpoint of the IPSec tunnel	Type the IPSec tunnel's local endpoint 32-bit IP address, in dotted decimal notation.
Remote Tunnel Endpoint (required)	Externally routable IP address that is the peer endpoint of the IPSec tunnel	Type the IPSec tunnel's peer endpoint 32-bit IP address, in dotted decimal notation.
IKE Secret Key (required)	Internet Key Exchange key (password) that is preshared to ensure authentication across the IPSec tunnel	Type the IKE key to be used for authentication across the IPSec tunnel. Characters are disguised as you type.
Verify IKE Secret Key (required)	Internet Key Exchange key that is preshared to ensure authentication across the IPSec tunnel	Verify the IKE key by retyping the key to be used for authentication across the IPSec tunnel. Characters are disguised as you type.
Private Prefix List	List of addresses or address prefixes for which the IPSec tunnel is used. Packets whose destination address matches any of the addresses or prefixes in this list are transported through the IPSec tunnel to the remote tunnel endpoint.	In the text box at the bottom of the list, type an IP address or address prefix. For example: 10.10.10.10/24 Click Add. Click OK.