[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring BGP for CLNS

To configure BGP to carry CLNS VPN NLRI:

  1. Navigate to the top of the configuration hierarchy in either the J-Web or the CLI configuration editor.
  2. Perform the configuration tasks described in Table 26.
  3. If you are finished configuring the router, commit the configuration.
  4. To verify the configuration, see Verifying CLNS VPN Configuration.

Table 26: Configuring BGP to Carry CLNS VPN NLRI Messages

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Bgp level in the configuration hierarchy.
  1. In the J-Web interface, select Configuration>View and Edit>Edit Configuration.
  2. Next to Protocols, click Configure or Edit.
  3. Next to Bgp, click Configure or Edit.

From the [edit] hierarchy level, enter

set protocols bgp group pedge-pedge neighbor 10.255.245.215 family iso-vpn unicast

Define a BGP group name—for example, pedge-pedge.
  1. Next to Group, click Add new entry.
  2. In the Group name box, type pedge-pedge.

Define a BGP peer neighbor address for the group—for example, 10.255.245.215.
  1. Next to Neighbor, click Add new entry.
  2. In the Address box, type 10.255.245.215.

Define the family.
  1. Under Family, next to Iso vpn, click Configure.
  2. Next to Unicast, select the Yes box.
  3. Click OK.
[Contents] [Prev] [Next] [Index] [Report an Error]

[an error occurred while processing this directive]