[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
Adding a RADIUS Server for
Authentication
You can use the Users Quick Configuration page for RADIUS servers to
configure a RADIUS server for system authentication. This Quick Configuration
page allows you to specify the IP address and secret (password) of the RADIUS
server.
Figure 1 shows the Users Quick Configuration
page for RADIUS servers.
Figure 1: Users Quick Configuration Page for RADIUS
Servers
To configure a RADIUS server with Quick Configuration:
- In the J-Web interface, select Configuration>Quick
Configuration>Users.
- Under RADIUS servers, click Add to
configure a RADIUS server.
- Enter information into the Users Quick Configuration page
for RADIUS servers, as described in Table 8.
- Click one of the following buttons on the Users Quick Configuration
page for RADIUS servers:
- To apply the configuration and return to the Users Quick Configuration
page, click OK.
- To cancel your entries and return to the Users Quick Configuration
page, click Cancel.
Table 8: Users Quick Configuration
for RADIUS Servers Summary
|
Field
|
Function
|
Your Action
|
| RADIUS Server
|
|
RADIUS Server Address (required)
|
Identifies the IP address of the RADIUS server.
|
Type the RADIUS server’s 32-bit IP address, in dotted decimal
notation.
|
|
RADIUS Server Secret (required)
|
The secret (password) of the RADIUS server.
|
Type the secret (password) of the RADIUS server. Secrets can contain
spaces. The secret used must match that used by the RADIUS server.
|
|
Verify RADIUS Server Secret (required)
|
Verifies the secret (password) of the RADIUS server is entered correctly.
|
Retype the secret of the RADIUS server.
|
[Contents]
[Prev]
[Next]
[Index]
[Report an Error]