[Contents] [Prev] [Next] [Index] [Report an Error]

Unpacking the J-series Services Router

The Services Router is shipped in a cardboard carton and secured with foam packing material. The carton also contains an accessory box and quick start instructions.

The router is maximally protected inside the shipping carton. Do not unpack it until you are ready to begin installation.

To unpack the router:

  1. Move the shipping carton to a staging area as close to the installation site as possible, but where you have enough room to remove the router.
  2. Position the carton so that the arrows are pointing up.
  3. Open the top flaps on the shipping carton.
  4. Remove the accessory box, and verify the contents against the parts inventory on the label attached to the carton.
  5. Pull out the packing material holding the router in place.
  6. Verify the contents of the carton against the packing list included with the router. A generic parts inventory appears in Table 44.
  7. Save the shipping carton and packing materials in case you later need to move or ship the router.

Table 44: Generic Inventory of Services Router Shipping Carton

Component

J2300 Services Router

J4300 Services Router

J6300 Services Router

Chassis

1

1

1

Physical Interface Module (PIM)

2 Fast Ethernet ports and one of the following sets of interfaces:

  • 2 E1 ports
  • 2 E1 ports and 1 ISDN BRI S/T port
  • 2 serial ports
  • 2 serial ports and 1 ISDN BRI S/T or U port
  • 2 T1 ports
  • 2 T1 ports and 1 ISDN BRI U port
  • 2 G.SHDSL ports
  • 2 G.SHDSL ports and 1 ISDN BRI S/T port

Note:

The interfaces installed in the J2300 Services Router are not field-replaceable. For more information, see J2300 Chassis with Fixed PIMs.

Between 0 and 6 of the following in any combination:

  • 1–port ADSL Annex A or Annex B PIM
  • 2-port G.SHDSL Annex A or Annex B PIM
  • 1-port DS3 (T3) PIM (J6300 routers only)
  • 2-port E1 PIM
  • 1-port E3 PIM (J6300 routers only)
  • 2-port Fast Ethernet PIM
  • 4-port ISDN BRI S/T or U PIM
  • 2-port serial PIM
  • 2-port T1 PIM

Power supply

1 (fixed)

1 (fixed)

1 or 2

Mounting brackets

2

2 (fixed)

2 (fixed)

Blank panels for slots without components

0

Depends on router configuration

Depends on router configuration
[Contents] [Prev] [Next] [Index] [Report an Error]

[an error occurred while processing this directive]