Configuring a Single-Area OSPF Network (Required)

To use OSPF on the Services Router, you must configure at least one OSPF area, like the one shown in Figure 65.

Figure 65: Typical Single-Area OSPF Network Topology

Image g015028.gif

To configure a single-area OSPF network with a backbone area, like the one in Figure 65, perform these steps on each Services Router in the network:

Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
Perform the configuration tasks described in Table 79.
If you are finished configuring the router, commit the configuration.
After you create the backbone area and add the appropriate interfaces to the area, OSPF begins sending LSAs. No additional configuration is required to enable OSPF traffic on the network.
Go on to one of the following procedures:
- To add more areas to the AS, see Configuring a Multiarea OSPF Network (Optional).
- To control external route advertisement in the AS, see Configuring Stub and Not-So-Stubby Areas (Optional).
- To configure an OSPF demand circuit, see Configuring Dial-on-Demand Routing Backup with OSPF Support (Optional). (You must have already configured an ISDN interface as described in Configuring ISDN.)
- To improve network operation, see Tuning an OSPF Network for Efficient Operation.
- To check the configuration, see Verifying an OSPF Configuration.

Table 79: Configuring a Single-Area OSPF Network

Task	J-Web Configuration Editor	CLI Configuration Editor
Navigate to the Ospf level in the configuration hierarchy.	In the configuration editor hierarchy, select Protocols>Ospf.	From the top of the configuration hierarchy, enter edit protocols ospf
Create the backbone area with area ID 0.0.0.0.	In the Area box, click Add new entry. In the Area ID box, type 0.0.0.0.	Set the backbone area ID to 0.0.0.0 and add an interface: set area 0.0.0.0 interface fe-0/0/0 Repeat Step 1 for each interface on this Services Router that you are adding to the backbone area. Only one interface is required.
Add interfaces as needed to the OSPF area—for example, fe-0/0/0.	In the Interface box, click Add new entry. In the Interface name box, type fe-0/0/0. Click OK. Repeat Step 1 through Step 3 for each interface on this Services Router that you are adding to the backbone area. Only one interface is required.

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Ospf level in the configuration hierarchy.

In the configuration editor hierarchy, select Protocols>Ospf.

From the top of the configuration hierarchy, enter

edit protocols ospf

Create the backbone area with area ID 0.0.0.0.

Set the backbone area ID to 0.0.0.0 and add an interface:
set area 0.0.0.0 interface fe-0/0/0
Repeat Step 1 for each interface on this Services Router that you are adding to the backbone area. Only one interface is required.

Add interfaces as needed to the OSPF area—for example, fe-0/0/0.

In the Interface box, click Add new entry.
In the Interface name box, type fe-0/0/0.
Click OK.
Repeat Step 1 through Step 3 for each interface on this Services Router that you are adding to the backbone area. Only one interface is required.