[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring DLSw on the Remote Services Router

To configure DLSw on the remote Services Router, you do the following:

Define a local peer.
Define a remote peer.
Finally, define the connection behavior.

To configure DLSw on a remote router:

Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
Perform the configuration tasks described in Table 55.
If you are finished configuring the router, commit the configuration.
To verify the DLSw configuration, see Verifying DLSw Configuration.

Table 55: Configuring DLSw on the Remote Router

Task	J-Web Configuration Editor	CLI Configuration Editor
Navigate to the Dlsw level in the configuration hierarchy.	In the configuration editor hierarchy, select Protocols>Dlsw. Click Configure.	From the top of the configuration hierarchy, enter edit protocols dlsw
Configure the local router properties. promiscuous—Allows all incoming peer connections.	In the Local peer box, type 217.110.111.134. Next to Promiscuous, select Yes. Click OK.	Enter set local-peer 217.110.111.134 Enter set promiscuous

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Dlsw level in the configuration hierarchy.

In the configuration editor hierarchy, select Protocols>Dlsw.
Click Configure.

From the top of the configuration hierarchy, enter

edit protocols dlsw

Configure the local router properties.

promiscuous—Allows all incoming peer connections.

In the Local peer box, type 217.110.111.134.
Next to Promiscuous, select Yes.
Click OK.

Enter
set local-peer 217.110.111.134
Enter
set promiscuous

If the values connection-idle-timeout, dlsw-cos, local-peer, multicast-address, promiscuous, and receive-initial-pacing are modified, any existing DLSw peer connection is torn down. If remote-peer peer-address is added or removed, only that remote peer and its associated circuits are affected.

[Contents] [Prev] [Next] [Index] [Report an Error]