[Contents] [Prev] [Next] [Index] [Report an Error]

Halting the Services Router with the CLI

You can use the request system halt CLI command to halt the Services Router:

user@host> request system halt <at time>
<in minutes> <media type>
<message “text”>

When the router is halted, all software processes stop and you can access the router through the console port only. Reboot the router by pressing any key on the keyboard.

If you cannot connect to the router through the console port, shut down the router by pressing and holding the power button on the front panel until the POWER ON LED turns off. After the router has shut down, you can power on the router by pressing the power button again. The POWER ON LED lights during startup and remains steadily green when the router is operating normally.

Table 129 describes the request system halt command options.

Table 129: CLI Request System Halt Command Options

Option	Description
none	Same as at now (stops software processes on the router immediately).
at time	Time at which to stop the software processes on the router. You can specify time in one of the following ways: now—Stops the software processes immediately. This is the default. +minutes—Stops the software processes in the number of minutes from now that you specify. yymmddhhmm—Stops the software processes at the absolute time you specify. Enter the year, month, day, hour (in 24-hour format), and minute. hh:mm—Stops the software processes at the absolute time that you specify, on the current day. Enter the time in 24-hour format, using a colon (:) to separate hours from minutes.
in minutes	Specifies the number of minutes from now to stop the software processes on the router. This option is a synonym for the at +minutes option.
media type	Specifies the boot device to boot the router from after the halt: compact-flash—Reboots from the primary compact flash drive. This is the default. removable-compact-flash—Reboots from the optional removable compact flash drive. This option is available on J4300 and J6300 Services Routers only. usb—Reboots from the USB storage device.
message "text"	Provides a message to display to all system users before the software processes on the router are stopped.

[Contents] [Prev] [Next] [Index] [Report an Error]