[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring ISDN Dialer Interfaces with Quick Configuration

When ISDN interfaces are installed on the Services Router, links to ISDN Quick Configuration pages for dialer options are displayed on the Interfaces Quick Configuration page as shown in Figure 35.

You can use these Quick Configuration pages to configure a dialer interface for either dial backup or dialer watch. For dial backup you specify the serial interface to back up. For dialer watch you specify a watch list of one or more routes to monitor.

Figure 35: ISDN Dialer Options Quick Configuration Page

Image s020061.gif

To configure ISDN interfaces with Quick Configuration:

In the J-Web interface, select Configuration>Quick Configuration>Interfaces.
A list of network interfaces installed on the Services Router is displayed.
Click ISDN Dialer Options under the interfaces list.
Select a backup method to configure on the dialer interface:
- Click Dial Backup to allow one or more dialer interfaces to back up the primary serial interface. The backup interfaces are activated only when the primary interface fails.
- Click Dialer Watch to monitor a specified route and initiate dialing of the backup link if that route is not present.
Do one of the following:
- To edit an existing dialer interface, click the dialer interface name.
- To add a dialer interface, click Add. In the Interface Name box, type a name for the logical interface—for example, dl1, then click Add under Logical Interfaces.
Figure 36 shows the ISDN Quick Configuration page for dialer logical interfaces.

Figure 36: ISDN Dialer Interface Quick Configuration Page
Enter information into the ISDN Quick Configuration page for dialer logical interfaces, as described in Table 46.
Click one of the following buttons on the ISDN Quick Configuration page:
- To apply the configuration and stay on the current Quick Configuration page, click Apply.
- To apply the configuration and return to the previous Quick Configuration page, click OK.
- To cancel your entries and return to the previous Quick Configuration page, click Cancel.
To verify that the ISDN interface is configured correctly, see Verifying the ISDN Configuration.

Table 46: ISDN Dialer Interface Quick Configuration Page Summary

Configuring Dialer Interfaces
Logical Interface Description	Describes the logical interface.	Type a text description of the interface in the box.
IPv4 Addresses and Prefixes	Displays the IPv4 addresses for the interfaces to which the dialer interface is assigned.	Type an IP address and a prefix in the boxes. Click Add. To delete an IP address, highlight it in the list, and click Delete.
Dialer Options
Activation Delay	Displays the time to wait before activating the backup interface once the primary interface is down.	Type a value, in seconds—for example, 30. The default value is 0 seconds with a maximum value of 60 seconds.
Deactivation Delay	Displays the time to wait before deactivating the backup interface once the primary interface is up.	Type a value, in seconds—for example, 30. The default value is 0 seconds with a maximum value of 60 seconds.
Dial String (required)	Displays the dialing number from your ISDN service provider.	Type the dialing number and click Add. To delete a dial string, highlight it and click Delete.
Pool (required)	Displays a list of dialer pools configured on br interfaces.	Select a dialer pool from the list.
Backup Interface (for dial backup only)
Interface to Backup	Displays a list of interfaces for ISDN backup.	Select an interface from the list for ISDN backup.
Dialer Watch List (for dialer watch only)
IPv4 Addresses and Prefixes	Displays the IPv4 addresses in the list of routes to be monitored by the dialer interface.	Type an IP address and a prefix in the boxes. Click Add. To delete an IP address, highlight it in the list, and click Delete.

[Contents] [Prev] [Next] [Index] [Report an Error]