Removing the USB Storage Device

Depending on your configuration, the Services Router might not have a USB storage device. If no USB storage device is installed, proceed directly to the next section, Installing the USB Storage Device.

The USB storage device is installed into the USB port on the front panel of the Services Router. To remove the USB storage device:

1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see Preventing Electrostatic Discharge Damage.
3. Verify that the router did not boot from the USB storage device by issuing the show system storage command from the CLI. For example:
   user@host> show system storage

   Filesystem        512-blocks       Used      Avail Capacity Mounted on
   /dev/ad0s1a           218254     175546      40526     81%  /
   ...

   The boot device is mounted on /. The primary compact flash disk is located at ad0. The removable compact flash disk is located at ad2. The USB storage device is located at usb0. This example shows that the router booted from the primary compact flash disk.

4. If the show system storage output indicates that the router booted from the USB storage device, press and release the power button to power off the router. Wait for the POWER ON LED to turn off before you remove the USB storage device.
5. Gently grasp the USB storage device and slide it out of the USB port.
6. Place the USB storage device on the antistatic mat or in the electrostatic bag.