 |
Do not leave a power supply slot empty for more than a short time while the Services Router is operational. The power supply or a blank power supply panel must remain in the chassis for proper airflow. |
The J6300 Services Router has one or two load-sharing AC or DC power supplies (see Figure 10 or Figure 11), located at the right rear of the chassis. Each power supply provides power to all components in the router. The power supplies are fully redundant. If one power supply fails or is removed, the remaining power supply instantly assumes the entire electrical load. One power supply can provide full power for as long as the router is operational.
Each J6300 power supply is hot-insertable and hot-removable.
|
Do not leave a power supply slot empty for more than a short time while the Services Router is operational. The power supply or a blank power supply panel must remain in the chassis for proper airflow. |
To replace a power supply in a J6300 router, use the following procedures: