Configuring PPPoE Encapsulation on an Ethernet Interface

Both the client and the server must be configured to support PPPoE.

To configure PPPoE encapsulation on an Ethernet interface:

Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
Perform the configuration tasks described in Table 37.
If you are finished configuring the router, commit the configuration.
Go on to one of the following procedures:
- To configure the PPPoE interface, see Configuring a PPPoE Interface (Required).
- To enable authentication on the interface, see Configuring CHAP (Optional).
- To check the configuration, see Verifying a PPPoE Configuration.

Table 37: Configuring PPPoE Encapsulation on an Ethernet Interface

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Interfaces level in the configuration hierarchy.

In the configuration editor hierarchy select Interfaces.

From the top of the configuration hierarchy, enter

edit interfaces

Configure encapsulation on a logical Ethernet interface—for example, fe-0/0/1.0.

Set PPP encapsulation on unit 0 of the Ethernet interface:

set fe-0/0/1 unit 0 encapsulation ppp-over-ether