Configuring an IPSec Tunnel with Quick Configuration

J-Web Quick Configuration allows you to create IPSec tunnels. Figure 74 shows the Quick Configuration page for IPSec tunnels.

Figure 74: Quick Configuration Page for IPSec Tunnels

Image s020030.gif

To configure an IPSec tunnel with Quick Configuration:

In the J-Web user interface, select Configuration>IPSec Tunnels.
Enter information into the Quick Configuration page for IPSec Tunnels, as described in Table 105.
From the IPSec Tunnels Quick Configuration page, click one of the following buttons:
- To apply the configuration and return to the Quick Configuration IPSec Tunnels page, click OK.
- To cancel your entries and return to the Quick Configuration for IPSec Tunnels page, click Cancel.
To check the configuration, see Verifying the IPSec Tunnel Configuration.

Table 105: IPSec Tunnels Quick Configuration Summary

Field	Function	Your Action
Tunnel Information
Local Tunnel Endpoint (required)	Externally routable IP address that is the local endpoint of the IPSec tunnel	Type the IPSec tunnel's local endpoint 32-bit IP address, in dotted decimal notation.
Remote Tunnel Endpoint (required)	Externally routable IP address that is the peer endpoint of the IPSec tunnel	Type the IPSec tunnel's peer endpoint 32-bit IP address, in dotted decimal notation.
IKE Secret Key (required)	Internet Key Exchange key that is preshared to ensure authentication across the IPSec tunnel	Type the IKE key to be used for authentication across the IPSec tunnel. Characters are disguised as you type.
Verify IKE Secret Key (required)	Internet Key Exchange key that is preshared to ensure authentication across the IPSec tunnel	Verify the IKE key by retyping the key to be used for authentication across the IPSec tunnel. Characters are disguised as you type.
Private Prefix List	List of addresses or address prefixes for which the IPSec tunnel is used. Packets whose destination address matches any of the addresses or prefixes in this list are transported through the IPSec tunnel to the remote tunnel endpoint.	In the text box at the bottom of the list, enter an IP address or address prefix, in dotted decimal notation. Click Add.