Configuring a RIP Network with Quick Configuration

J-Web Quick Configuration allows you to create RIP networks. Figure 54 shows the Quick Configuration Routing page for RIP.

Figure 54: Quick Configuration Routing Page for RIP

Image s020025.gif

To configure a RIP network with Quick Configuration:

In the J-Web user interface, select Configuration>Routing>RIP Routing.
Enter information into the Quick Configuration page for RIP, as described in Table 61.
From the main RIP routing Quick Configuration page, click one of the following buttons:
- To apply the configuration and stay on the Quick Configuration Routing page for RIP, click Apply.
- To apply the configuration and return to the Quick Configuration Routing page, click OK.
- To cancel your entries and return to the Quick Configuration Routing page, click Cancel.
To check the configuration, see Verifying the RIP Configuration.

Table 61: RIP Routing Quick Configuration Summary

Field	Function	Your Action
RIP
Enable RIP	Enables or disables RIP.	To enable RIP, select the check box. To disable RIP, clear the check box.
Advertise Default Route	Advertises the default route using RIPv2.	To advertise the default route using RIPv2, select the check box. To disable the default route advertisement, clear the check box.
RIP-Enabled Interfaces	Designates one or more Services Router interfaces on which RIP is enabled.	The first time you configure RIP, the Logical Interfaces box displays a list of all the logical interfaces configured on the Services Router. Do any of the following: To enable RIP on an interface, click the interface name to highlight it, and click the left arrow to add the interface to the RIP interfaces list. To enable RIP on multiple interfaces at once, press Ctrl while you click multiple interface names to highlight them. Then click the left arrow to add the interfaces to the RIP interfaces list. To enable RIP on all logical interfaces except the special fxp0 management interface, select All Interfaces in the Logical Interfaces list and click the left arrow. To enable RIP on all the interfaces displayed in the Logical Interfaces list, click All to highlight every interface. Then click the left arrow to add the interfaces to the RIP interfaces list. To disable RIP on one or more interfaces, highlight the interface or interfaces in the RIP interfaces box and click the right arrow to move them back to the Logical Interfaces list.