Configuring LLC2 Properties on an Ethernet Interface (Required)

Before configuring DLSw on the Services Router, you must configure the LLC2 properties on the Ethernet interfaces of the router. The Logical Link Control (LLC) layer is one of two sublayers into which the OSI data link layer is subdivided for data link protocols used on the LAN. LLC2 is implemented anytime SNA is running on a LAN or virtual LAN.

LLC2 properties must be configured on the local Services Router and the remote Services Router.

To configure LLC2 properties:

1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
2. Perform the configuration tasks described in Table 118.
3. Go on to one of the following required configurations:
   • To configure DLSw on the local Services Router, go on to Configuring DLSw on the Local Services Router (Required).
   • To configure DLSw on the remote Services Router, go on to Configuring DLSw on the Remote Services Router (Required).
4. To verify the basic DLSw properties, see Verifying DLSw Configuration.

Table 118: Configuring LLC2 Properties on a Fast Ethernet Interface