Configuring DLSw on the Remote Services Router (Required)

To configure DLSw on the remote Services Router, you do the following:

• Define a local peer.
• Define a remote peer.
• Finally, define the connection behavior.

To configure DLSw on a remote router:

1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
2. Perform the configuration tasks described in Table 121.
3. If you are finished configuring the router, commit the configuration.
4. To verify the DLSw configuration, see Verifying DLSw Configuration.

Table 121: Configuring DLSw on the Remote Router