Configuring DLSw on the Local Services Router (Required)

To configure DLSw on the local Services Router, you do the following:

• Define a local peer.
• Define a remote peer.
• Finally, define connection behavior.

The example in this section shows how to configure DLSw on the local and remote Services Routers with IP addresses listed in Table 119. The remote Services Router initiates the peer connection.

Table 119: Sample DLSw Peer Router Values

In this example, the local router is configured with remote-peer settings because the local router is initiating the connection for SNA traffic over the WAN interface. The remote router is accepting DLSw connections from any DLSw peers.

To configure basic DLSw on the local router:

1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
2. Perform the configuration tasks described in Table 120.
3. Go on to Configuring DLSw on the Remote Services Router (Required).

Table 120: Configuring DLSw on the Local Router