Removing a Power Supply in a J6300 Router

The power supplies are located at the right rear of the chassis. A power supply weighs 2.4 lb (1.1 kg).

Do not leave a power supply slot empty for more than a short time while the Services Router is operational. The power supply or a blank power supply panel must remain in the chassis for proper airflow.

To remove a power supply from a J6300 Services Router:

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see Preventing Electrostatic Discharge Damage.
2. Unplug the power cord from the power source receptacle.
3. Unplug the power cord from the appliance inlet on the power supply faceplate.
4. Slide the red ejector tab on the power supply faceplate to the right and hold it in place, to unlock the power supply.
5. Grasp the handle on the power supply faceplate, and pull firmly to start removing the power supply. Slide it halfway out of the chassis (see Figure 40).
6. Place one hand underneath the power supply to support it and slide it completely out of the chassis.
7. If you are not reinstalling a power supply into the emptied slot, install a blank power supply panel over the slot.