Installing the Removable Compact Flash Disk

To install the removable compact flash disk, follow this procedure (see Figure 35):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see Preventing Electrostatic Discharge Damage.
2. Slide the compact flash door up to unlatch the door, then tilt the top of the door out (see Figure 35).
3. Slide the compact flash disk into the connector on the Routing Engine.
4. Tilt the compact flash door in, and slide it down until it is secured.
5. To configure the removable compact flash disk with the request system snapshot command, see the J-series Services Router Administration Guide.