[Contents] [Prev] [Next] [Index] [Report an Error]

Power Button and POWER ON LED

The power button is located on the left side of the front panel (see Figure 4). You can use the power button to power the Services Router on and off. When you power on the router, the Routing Engine boots as the power supply completes its startup sequence.

The POWER ON LED is located to the left of the power button on the front panel. Table 9 describes the POWER ON LED.

Table 9: POWER ON LED

Color	State	Description
Green	Off	Router is unplugged, or is powered off and in standby mode.
	On steadily	Router is powered on and is either booting or functioning normally.
	Blinking	Power button has been pressed and quickly released, and the router is gracefully shutting down.

After the router is powered on, status indicators—such as LEDs on the front panel and show chassis command output—can take up to 60 seconds to indicate that the power supply is functioning normally. Ignore error indicators that appear during the first 60 seconds.

If you need to power off the router after the Routing Engine finishes booting, use the J-Web interface or the CLI to halt the Services Router first. For instructions, see the J-series Services Router Administration Guide.

[Contents] [Prev] [Next] [Index] [Report an Error]