Configuring a Basic Set of Static Routes (Required)

Customer routes that are connected to stub networks are often configured as static routes. Figure 40 shows a sample network.

To configure customer routes as static routes, like the ones in Figure 40, follow these steps on the Services Router to which the customer routes are connected:

1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.
2. Perform the configuration tasks described in Table 34.
3. If you are finished configuring static routes, commit the configuration.
4. Go on to one of the following procedures:
   • To manually control static route selection, see Controlling Static Route Selection (Optional).
   • To determine how static routes are imported into the routing and forwarding tables, see Controlling Static Routes in the Routing and Forwarding Tables (Optional).
   • To define default properties for static routes, see Defining Default Behavior for All Static Routes (Optional).
   • To check the configuration, see Verifying the Static Route Configuration.

Table 34: Configuring Basic Static Routes