recovery-timeout
Syntax
recovery-timeout seconds;
Hierarchy Level (EX Series and QFX Series)
[edit interfaces interface-name unit 0 family ethernet-switching]
Hierarchy Level (MX Series)
[edit interfaces interface-name unit 0 family bridge]
Description
Configure an interface to be temporarily disabled when MAC limiting, MAC
move limiting, or rate-limiting is in effect with the action shutdown. This enables
the affected interface to recover automatically from the error condition after the specified
period of time:
If you configure MAC limiting with the
shutdownoption and you enablerecovery-timeout, the interface is temporarily disabled when the MAC address limit is reached. The interface will recover automatically after the number of seconds specified.If you enable MAC move limiting with the
shutdownoption and you enablerecovery-timeout, the interface is temporarily disabled when the maximum number of MAC address moves is reached. The interface will recover automatically after the number of seconds specified.If you enable MAC move limiting with the
vlan-member-shutdownoption and you enablerecovery-timeout, the interface is temporarily disabled when the maximum number of MAC address moves is reached. The interface will recover automatically after the number of seconds specified. If the recovery timeout is not configured, the interface will recover automatically after 180 seconds.If you enable storm control with the
action-shutdownoption and you enablerecovery-timeout, the interface is temporarily disabled when applicable traffic exceeds the specified levels. Depending upon the configuration, applicable traffic can include broadcast, unknown unicast, and multicast traffic.
The recovery-timeout configuration does not apply to preexisting error
conditions. It impacts only error conditions that are detected after the recovery-timeout statement is configured and committed. To clear a preexisting error condition and restore
the interface to service, use the operational mode commands clear ethernet-switching recovery-timeout for EX Series and QFX Series
and clear bridge recovery-timeout for MX
Series routers.
Default
The interface does not automatically recover from an error condition.
On EX9200 switches, if a MAC move limit is configured with the action vlan-member-shutdown, the interface automatically recovers from the disabled condition after 180 seconds
by default.
Options
| seconds | Number of seconds that the interface remains in a disabled state due to a port error prior to automatic recovery. |
Range: 10 through 3600
Required Privilege Level
system—To view this statement in the configuration.system–control—To add this statement to the configuration.
Release Information
Statement introduced in Junos OS Release 13.2X50-D10.